Enable/Setup WIFI, will not respond

Mitsubishi Outlander PHEV Forum

Help Support Mitsubishi Outlander PHEV Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

phevnor

Active member
Joined
Jan 1, 2017
Messages
35
Location
Norway
Own for two days a 2014. The car look new and is great.
Trying to connect to the car with my iphone. Follows the procedure found on net, but there seems to be no responce from the 10 Lock/Unlock pressing while ACC:
The car have WIFI, as the card with SSD and psw were given to med from the seller.

Is there anyhing else to activate?
 
The setup procedure is very, very, fiddly.

Once you've achieved it once, you'll have no problems doing it again.

The key is the timing, quoting from the instructions, note the highlighted parts.

STEP1 Setup your vehicle and wireless device so they can be registered.

(Perform this operation while the driver-side door is closed.)
Turn the power switch to ACC, then within 10 seconds, press LOCK and UNLOCK on the key fob alternately 10 times in total.

You must complete the operation within ten seconds.

So, you turn the car off.
Turn it on into ACC (turn it on without putting your foot on the brake)
Immediately start clicking the lock and unlock buttons on the fob, like a mad man!

Have fun.

Andy
 
Been playing on/off and seems to be that I haven-t got a model with the remote WIFI and preheat function installed.

Made a VIN search and this camup as data (among a lot of other things)
QUICK CHARGER; EV REMOTE SYSTEM; DON'T INSTALL SPL MAKE TIRE

It states EV REMOTE SYSTEM, then DON't INSTALL SPL.
Also yesterday I took the panell of in rear, and the remote unit is isntalled, but I am not sure if it is the WIFI one.
Vindata:
https://drive.google.com/open?id=1Fm6TsZMhWl_7JgDhXRa7IrvetSo9P261WT6wtM_gx1M

The remote unit:
https://drive.google.com/open?id=0B1Rc6U-4KJ0ZdWR2Z1o4MDZyM28
 
Try the DELETE REGISTRATION process first.

1. Get in the car and close the driver's side door
2. Put on the hazard lights
3. Put the car into ACC mode (press start without putting your foot on the brake)
4. Press lock and then unlock alternatively on the key fob (ten presses in total)

Listen for beeps.

No registration : 1 beep
1 device has been registered : 2 beeps
2 devices have been registered : 3 beeps

We're expecting that you'll hear 3 beeps. :p
 
Back
Top